Product Overview
Brand: Casmer
Color: White-Backlit LCD Screen
Features:
- Not OEM:Our product is not OEM manufactured, and all brands and models mentioned in the product description indicate compatibility.Lifetime GNTEE service provided for damages caused by non-human factors
- Adapted For ambient Fireplaces: Designed for ambient standard millivolt gas fireplaces only, replacing the ambient fireplace remote control (RCB), Replacement for ambient RCM-RX / RMC RX receivers,Receiver for RCT RCM RCMT RCT RCST RCB TLM TLT WWTD and WMTD transmitters
- Without Battery:Casmer gas fireplace remote control kit is all transported by air and does not include batteries.You will need to additional purchase (3) AAA and (4) AA batteries. We believe you can purchase them at any store. Note: Please do not place the receiver too close to a flame, the maximum operating temperature of the signal receiver is 120℉. Exceeding 115℉ may lead to battery leakage and shorter service life, causing damage to electronic components
- 【Installation Steps】Ensure fireplace & valve are off and cooled. 1. Install receiver batteries. Wires are non-polarized. - No module: Connect to TH/TH/TP on millivolt valve. - With OEM millivolt module: Connect to thermostat/remote terminals. 2. Remote & receiver pre-paired; re-pair if needed. 3. Push & turn knob to PILOT, hold. Light pilot with piezo igniter, or long lighter at pilot hood until steady blue flame shows. 4. Hold PILOT knob 30–60s to heat thermopile. 5. Release knob, confirm pilot stays lit, then turn to ON. 6. With pilot burning, toggle main burner on/off via remote. Remote does not control pilot. 7. Shutdown: Turn knob to OFF. Flames extinguish. Re-light pilot next use
- 【Notes】1. Batteries sold separately. Transmitter:2 AA; Receiver:4 AA (optional). 2. Re-pair if pairing lost after long idle time. 3. Replace transmitter & receiver as a set. 4. Manually shut fireplace & gas valve for long non-use. 5. Keep away from children and open flames. 6. Same steps for both wiring ways. Do NOT connect to thermopile power, ignition probe, flame sensor, fan or 120V terminals. Not for 120V IPI fireplaces.
